Introduction to maintenance requirements of automatic cutting machine?

Introduction to maintenance requirements of automatic cutting machine?

The operator is responsible for the daily maintenance of the cutting machine, the operator should know the equipment structure abide by the operation maintenance regulations.

(1) Before the start of work (shift intermittent work), the main departments of the machine should be inspected filled with lubricating oil.

(2) In the class, use the equipment strictly according to the equipment operation rules, pay attention to observe the operation of the equipment, deal with the problems give lectures in time.

(3) Before the end of each shift, a cleaning work should be carried out, the friction surface bright surface should be coated with lubricating oil.

(4) Under the normal working condition of two shifts, the machine shall be cleaned inspected once every two weeks.

(5) If the machine is to be used for a long time, all bright surfaces must be wiped clean coated with antirust oil covered with plastic cover.

(6) Do use proper tools unfair knocking methods when disassembling assembling the machine.

(7) The hydraulic cutting machine should change the hydraulic oil regularly (once a year), check whether the filter screen is blocked cracked, whether there is oil leakage in the oil cylinder parts.

Technical safety precautions

(1) After the installation of the machine, it is necessary to ensure that the safety protection devices are complete the lines pipelines are complete. Properly ground the motor.

(2) When the machine is repaired, adjusted, refuelled, wiped checked, the power supply should be blocked to avoid danger.

(3) Before turning on the machine, pay attention to the surrounding environment to see if there is anyone working under the machine.

(4) Homework, the workbench is allowed to place oil pot, tools other unrelated items.

(5) If there is an accident after driving, there is abnormal noise jamming, it is necessary to park the car immediately for inspection.

(6) When the machine is running, it is strictly forbidden to put your hand into the cutting area. Even in the case of parking, it is strictly forbidden to change knives adjust tools in the cutting area.

(7) It is necessary to check the braking Department frequently. In any case, the upper platen of the cutting machine shall have re cutting spontaneous movement (sliding).