Matters needing attention in using rocker cutting machine

Matters needing attention in using rocker cutting machine

Rocker cutting machine is a kind of cutting machine, which is very suitable for cutting small area non-metallic materials in industry. So, what problems should we pay attention to when using the rocker cutting machine? Introduce the problems we should pay attention to when using the rocker cutting machine.

1. When setting the cutting tool of the rocker cutting machine, you can loosen the setting hand wheel first, so that the setting rod should touch the control switch of the cutting point. Otherwise, when the cutter setting switch of the rocker cutting machine is turned to on, the set action cannot be generated.

2. When you are working, the cutting knife of the rocker cutting machine should be placed in the center of the upper pressure plate as far as possible, so as to avoid the unilateral wear of the rocker cutting machine. The unilateral wear of the rocker cutting machine will affect the service life of the rocker cutting machine.

3. When replacing the cutting knife of the new rocker cutting machine, if the height is different, it is necessary to reset the cutter of the rocker cutting machine according to the setting method.

4. When you use the rocker cutting machine for cutting action, your hand must leave the cutting knife chopping board of the rocker cutting machine first. It is strictly forbidden to use your hand to assist the knife mold to cut, otherwise it is very dangerous.

5. If the operator wants to leave the position of rocker cutting machine temporarily, please be sure to turn off the motor switch to avoid damage to the machine due to improper operation. Also must avoid the overload use, lest damages the machine, thus reduces the service life.