How to install the automatic cutting machine correctly?

How to install the automatic cutting machine correctly?
First, the equipment should be placed on a flat cement floor, all parts should be checked to see if they are complete all lines are unobstructed.
Pay attention to cleaning the equipment avoid debris on the workbench.
Third, the hydraulic oil needs to be sprayed after the equipment is installed, the oil needs to be kept above the surface of the oil screen.
Fourth, when the power is connected, the button needs to be pressed to start the equipment management. The direction of the control motor needs to be adjusted, its direction the direction of the arrow need to be the same.

Reasons for uneven full pressure:
First, long-term overpressure use. The knife also causes insufficient pressure.
Second, the large workbench has been used for a long time with a small knife mold, it can be used away the center working position.
Third, the tool mold is used front back left right for a long time, it is used in a fixed position for a long time.
The oil pump is the power of the whole machine. If the oil pump is damaged leaks, the cutting machine will have insufficient oil pressure.
Based on the above reasons, uneven pressure cutting machines may occur, I hope it can help you.